Please note: The forum is now closed to new submissions. All the existing forum topics and posts are still available, however new topics cannot be created. If you need Sinclair C5 advice please use the C5 Owners Facebook Group.

andries.moss posted:

Hi all as you can see, I have been busy at work today.Flapper





posted on: 21/05/2014 19:05:22

andries.moss posted:

My repaired insert sort of worked.Not on 24v though. New insert ready to go in, but I was advised by Chas to make some cooling holes.
posted on: 21/05/2014 19:12:32

andries.moss posted:

The middle thingy.

posted on: 21/05/2014 19:52:45

andries.moss posted:

Plastic bit off and masking tape over the magnets. Ready for cooling holes to be drilled.

posted on: 21/05/2014 19:55:52

Area51 posted:

Good job so far Andries the motor looks fine
posted on: 21/05/2014 20:28:59

andries.moss posted:

Thanks Area 51

Holes drilled and back together.

posted on: 21/05/2014 20:56:30

andries.moss posted:

Greased and ready for gearbox. BigGrin



posted on: 21/05/2014 20:58:32

andries.moss posted:

Finished motor.
It is now back in the C5 and purring away happily on 24V.



posted on: 21/05/2014 21:02:01

andries.moss posted:

Now I want a night time test run....
posted on: 21/05/2014 21:04:35

andries.moss posted:

All good after two test runs. Max speed 43 kph / 26.5 mph. Only major problem now is the brakes. Ha ha What brakes. Tomorrow I will try a 12 mile loop to simulate the distance to my work.
posted on: 24/05/2014 10:07:33

dave posted:

Does them little holes help with cooling ?
posted on: 24/05/2014 19:32:40

Dan posted:

Great job you've done with the motor, those holes look like they'd help a lot
posted on: 24/05/2014 19:35:57

andries.moss posted:

The holes do help. I thought I maybe could have made them a bit bigger. But it did not get too hot.
posted on: 30/05/2014 10:13:13